Go to Top

Timber ID & Oven Dry MC Testing

Timber Identification

What We Do
Under the microscope analysis of wood cells to determine the likely botanical identification of a submitted species. Note however that species characteristics can be very similar and therefore the analysis may result in more than one species being possible, even with species that are well known.

What’s Required
At least 75mm long piece (or pieces) of the timber flooring in question – one piece for the standard fee test. The minimum thickness able to be examined is 3mm and width can be anything from 25mm wide upwards. It is also important to provide as much information about the sample as possible. This may include aspects such as when the timber was purchased, the approximate age of the building the sample was taken from, what the species was thought to be or had been sold as and whether the sample is typical in colour to the other wood present. If there is a concern over colour, samples should include the range of colour present. However note that samples sent must also contain heartwood (not the sapwood, which is the timber present beneath the bark and often distinctly lighter coloured wood).

Fees

  • Member $250.00 for one piece, $175 for each additional piece.
  • Non Member $300.00 for one piece, $200 for each additional piece.

Despatch Details
Samples should be sent to

ATFA Timber ID
c/- Planet Timbers
42 O’Malley St
OSBORNE PARK WA 6017.

Upon receipt of the samples you will be invoiced accordingly. Please supply your contact details including name, company (if applicable), phone, email, fax and postal details.

Oven Dry MC Testing

Oven dry testing provides the most accurate method of determining the moisture contents of timber flooring or timber subfloors. However, it is important that samples are correctly obtained and sent to atfa so as to minimise moisture loss.

Testing is carried out in accordance with AS 1080.1 Timber – Methods of test – Method 1: Moisture Content, and as such the procedures of the standard which includes transport of samples must be followed. Failure to do so can cause less meaningful results. Also note that oven dry testing is the only recognised method for testing particleboard and plywood subfloors. Oven dry testing is also necessary where either the timber species is not known or meter corrections are not available.

To obtain best results just follow the 5 steps below:

  1. Samples need to be representative of either a specific floor area of concern or in the case of a pack of flooring, the samples need to capture the variation present.
  2. From flooring packs or the jobsite, view the end of boards and choose some wider boards as well as some narrower boards. If some boards are cupped include these. If from packs select some outside boards as well as some from within the pack. Boards that are cupped or where cover widths vary by more than 1 mm (80mm wide boards) can be indicative of higher moisture content flooring at the time of installation.
  3. Provided the variation present can be captured, three or more samples each from different boards will provide a reasonable representation. If the flooring is all close to its nominal cover width (e.g. 80mm ± 0.5mm), then three samples from different boards including outside and inside boards from packs will suffice. Outside boards should be labeled as such. Do not use packing boards.
  4. Test samples are not to be from within 400mm of the end of a board and where possible should be 300mm in length.
  5. Samples are to be individually ‘plastic wrapped’ or put in separate sealed plastic bags. Samples should also be stored in cool conditions prior to dispatch to ATFA, 7 Coachwood Court, Mackenzie, QLD 4156 or in Western Australia please send to 42 O’Malley St Osborne Park WA 6017 with a copy of your request form.

To request an oven dry test please click here to download our order form.